21-23 April, 2027Pavilion 3, Crocus Expo, Moscow
RU
The Smartec family of ACS products has been replenished with ST-RC113RL switches, which consist of a receiver and a key transmitter that exchange data via a radio channel at a frequency of 433 MHz and a distance of up to 30 m
The device allows you to control actuating equipment such as electromechanical locks, gates, turnstiles or lighting. The wireless remote control switch can store up to 30 transmitters and supports three relay modes and can be programmed with just one button on the receiver body.
30 meters can reach the distance between the receiver and the ST-RC113RL transmitter in line of sight. The receiver relay is connected to actuating equipment, such as an electromechanical lock. This means that using this wireless remote control switch, it will be possible to open a door from a security checkpoint up to 30 m away. Note that the wireless mode involves the operation of the device at a permitted radio frequency of 433 MHz, and its power does not exceed 10 milliwatts.
With just one button, the transmitter allows you to control an access control device, such as a door lock. So, the novelty can be used instead of the exit button (or in addition to it) to unlock the door controlled by the ACS. In addition, the wireless remote control switch supports other actuators, such as gates, turnstiles, roller shutters, lighting fixtures, etc., working only in single-channel mode (with one of them). It should be noted that both parts of the ST-RC113RL set operate in the range from 0 to +45 °C, the receiver requires a 12 V DC power supply, and the transmitter requires an LR27A battery.
A large number of transmitters are supported by the ST-RC113RL remote control switch. It "remembers" up to 30 connected models (transmitters similar to those included in the kit can be purchased separately). At the same time, the wireless remote control switch provides a simple process for programming the transmitters. To enter the transmitter into memory, you will need to long press the programming button on the receiver body (3 seconds), followed by pressing the transmitter button and repeating the process. To delete all recorded transmitters, hold down the programming button for 8 seconds.
This set of wireless devices allows you to choose the mode of operation of the relay depending on the features and order of use at the facility. For example, the wireless remote control switch supports tracking, pulse and trigger modes of relay output. In the case of the tracking relay, it switches to the time of holding the transmitter button, in the case of pulse relay – for 3 seconds when the button is pressed, and in the trigger relay – when the button is pressed until the next press.